ERROR AssembleSpoolFile - Unable to open Spool file

[toram23901]

I just upgraded to 6.50 and I tried to get a download going, but I get the following:

[03:00:27] ERROR AssembleSpoolFile - Unable to open Spool file: "filename.ext" yEnc G:\Download\<filename.ext>.nb2
[03:00:27] ERROR INT_AssembleFile: Assembly Failed

Can someone point me in the right direction of where I should look? I believe I just choose to "upgrade" and everything looks like it is the same as before (6.40). I see my newsgroups and the settings are all the same.

This error happens with any file I choose to download a file. I tried looking for the error message, but I could not find anything specific about this. Thanks.

toram23901

[Quade]

Typically this means Newsbin can't write to the file when it tries to assemble it. Normally because the drive letter has changed, the drive has dropped offline or a permissions problem.

[toram23901]

Thank you. I went back to the directory and re-applied permissions. I believe this happened when Windows did asked me "Would you like to share this folder" earlier yesterday. I have no idea why Windows would decide to alter the directory permissions in doing this, but reapplying permissions worked for me.

Thanks.