Page 1 of 1
Display Settings
Posted:
Fri Jun 10, 2011 7:42 amby TBlack
I prefer Display Settings to be set at None, but it defaults to Show Filenames when I open a Group. Is this a setting that's off? I have to toggle the Display Settings after selecting a Group. Also, the setting does not stick for later opened Groups. Help!
Re: Display Settings
Posted:
Fri Jun 10, 2011 8:31 amby Quade
Someone else reported that. There was a setting in his NBI that was making it default to on.
If you know where your configuration file is you can open it with Wordpad and remove all "ShowFiles" entries. Then save, start Newsbin and see if this solves the problem.
Is this 32 or 64 bit windows?
ShowFiles=?
I'll see if I can reproduce it.
Re: Display Settings
Posted:
Fri Jun 10, 2011 4:34 pmby TBlack
Running 32-Bit XP SP3
Took out the showfiles line and no joy.
Running RC2 and now when I choose a group, it momentarily shows full file names and then switches to filenames only.
Re: Display Settings
Posted:
Fri Jun 10, 2011 4:57 pmby Quade
Next step is delete the "Workspace.xml" which resets the display. I'm tracking down an issue where it looks like workspace is getting damaged by something.
Re: Display Settings
Posted:
Fri Jun 10, 2011 7:08 pmby TBlack
OK, deleted Workspace.xml. Again, when I select a Group, I get a momentary flash of the full filename and then it goes to filename only.
Re: Display Settings
Posted:
Fri Jun 17, 2011 2:27 pmby TBlack
RC 3 fixes the Filename Display issues. Thanks
Re: Display Settings
Posted:
Fri Jun 17, 2011 3:04 pmby Quade
That's good to know. Thanks.